Revision: 20111222_121019 | All Revisions
The Contour ROAM comes in a hefty black box. The bullet cam is encased in a plastic case. The package gives off a sense of quality. After opening the package, you'll see that Contour provided you a nice protective case for the ROAM. It's transparent and works as a high quality display case to show off. Unfortunately, you won't be able to use the lens cap with the display case. A separate compartment in the display case allows you to store USB cable and other goodies.
Other than the quick start guide and the user manual, Contour provided the Rotating Flat Surface Mount, the Profile Mount, a USB cable, an extra adhesive pad for the Rotating Flat Surface Mount, a detachable strap, and a "CONTOUR" sticker.
The actual Contour ROAM cam is actually a lot bigger and heavier than I had imagined. From the photo on Amazon product page, I looked small and light weight. I thought it might have been made out of plastic. I had hoped to strap it to a sunglasses and use it on the go. But when it arrived, I realized my mistake. This action cam is made out of impact resistant aluminum body. It's shell has a really high-quality feel to it and it is solidly built. It's a bit too big and heavy for sunglasses. You'd probably look quite weird. Ski goggle might be more suitable.
The on/off switch on top is big and has a rubber surface. It will work wonderfully with gloves. The mount and back cover is made out of plastic. Not sure why Contour didn't use aluminum for these parts. A switch on the back cover locks and unlocks it for access to various interfaces. The switch is locked when a white dot is showing. It's unlocked otherwise. You slide the back cover up to open it.
The Contour ROAM offers three video modes and one still photo mode. In the video recording modes, you can choose between high and low quality.
In this video recording mode, the video resolution is 1920x1080, the aspect ratio is 16:9, and the field of view is 125 degrees. When the bit rate (quality) is set to high, a 1 GB memory card can store 8 minutes of 30 FPS video.
In this video recording mode, the video resolution is 1280x960, the aspect ratio is 4:3, and the field of view is 170 degrees. When the bit rate (quality) is set to high, a 1 GB memory card can store 10 minutes of 30 FPS video.
In this video recording mode, the video resolution is 1280x720, the aspect ratio is 16:9, and the field of view is 170 degrees. When the bit rate (quality) is set to high, a 1 GB memory card can store 15 minutes of 30 FPS video.
In this mode, the Contour ROAM captures still photos at various intervals. You can set the interval to 1, 3, 5, 10, 30, or 60 seconds. The 5 MP photo resolution is 2592x1944, which has an aspect ratio of 4:3. The field of view is 170 degrees.
The Contour ROAM has no filter thread in front of its lens. So if you are thinking of shooting special effect videos and photos with this bullet cam, then you are out of luck. Only special effects you can apply will have to be in post-processing on your computer.
Normally I don't install any software that comes with digital cameras and digital camcorders. I prefer to insert the memory card into my computer and copy them directly from the memory card. However, there is no way to change the Contour ROAM settings without using the Contour Storyteller companion software. So I downloaded the software from Contour's web site (see Related Links below) and installed it.
As soon as I started the software, it detected the 1.02 firmware on my Contour ROAM. It offered the newest firmware. When I approved, it download the newest firmware to the microSD Card. Then it loaded the firmware installation instruction (see Related Links below) on the web browser. The instruction basically tell you to disconnect the Contour ROAM and push the "Status" button to install the new firmware. After it's done, my Contour ROAM reported firmware version 1.06.
122 Users Online