Pinout information for the Canon EOS D30, D60, and 10D digital camera power accessory ... Canon DC Coupler DR-400 Pinout ... The picture above is the connector at ...

Information on extending the Canon RS60-E3 wired remote control.

So I attached a 9-volt battery to the BP-511 battery pack and plugged it into the Canon BG-ED3 Battery Grip (see photo below) and turned on the camera. Quite ...

The Canon BG-E1 Vertical Battery Grip is an accessory for the Canon EOS Digital Rebel SLR camera. It serves two purposes: 1) it allows two batteries to be ...

Several years ago, I bought an used Canon BG-E1 vertical battery grip for my Canon EOS Digital Rebel digital SLR camera. When I received the vertical grip ...

The Canon N3 shutter release trigger connector, found on higher-end Canon EOS cameras, has 3 connector pins. The male connector is designed onto the camera body ...

You can find the 9-volt battery snap connector at your local Radio Shack store. Have a ohm meter handy to figure out which wire goes to which connector. You'd ...

The battery pack has four electrical female pins. If you look at the bottom of the battery with the pins toward the top, you'll see that the left-most pin is ...

I am trying to remote control my Canon EOS Elan 7e with a remote control software on Sony Clie PDA. ... Canon remote, Nevo can learn the signal. Sadly, I have no ...

All three pins are spring-loaded and can fully retract into the connector body. Looking at the Canon T3 connector on the male side (on the remote switch), the ...